Introduction

Tension clamp is used for corner, connection, and terminal connection.Spiral aluminum clad steel wire has strong tensile strength, no concentrated stress, and plays a role in protecting and auxiliary shock absorption of optical cable.The whole set of fiber optic cable tensioning equipment includes: tensioning pre – stranded wire, supporting connection equipment.The cable grip force is not less than 95% of the rated tensile strength of the cable. The installation is convenient and fast, and the construction cost is reduced.It is suitable for ADSS cable line with spacing ≤ 100 meters and line Angle ＜25°

Anchor or tension clamps for all dielectric self-supporting cable (ADSS) are developed as a solution for aerial round fiber optic cables of different diameters. These optical fiber fittings installed on short spans (up to 100 meters). ADSS strain clamp is enough to keep the aerial bundled cables in tight strength position, and appropriate mechanical resistance archived by conical body and wedges, which does not allow the cable to slip from the ADSS cable accessory The ADSS cable route may be dead-end, double dead-ending or double anchoring.

Specification

 Product advantage

1. The wire clip has high strength and reliable grip.Clamp gripping strength not less than 95% Cuts (calculation of stranding force)
2. The stress distribution of the wire clamp on the stranded wire is uniform, without damage to the stranded wire, improving the seismic capacity of the stranded wire, and greatly prolonging the service life of the wire.
3. The installation quality of the wire clip is easy to ensure and can be inspected with the naked eye without the need for special training.
4. Good corrosion resistance, selection of high quality materials.The material is exactly the same as the wire to ensure that the wire clip has a strong ability to resist electrochemical corrosion

Details

Installation

Open the screw, place the wire into the groove and tighten the shearing head nut